Abstract
A general purpose 3D finite element method model has been developed for the estimation of the compression pressure distribution in fuel cell stacks. The model can be used for the optimisation of any type of fuel cell structure at any temperature. The model was validated with pressure sensitive film measurements using PEFC stack components that had low rigidity and were highly deformable.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
