Abstract
Abstract In this paper a model is presented for a surface acoustic wave (SAW) gas sensor. The model comprises the geometric design of the SAW device on a piezoelectric substrate, the electronic design of the amplifier running the SAW device and the selective film to be deposited onto the SAW device. This model has been implemented using a computer-aided engineering tool, J-Omega, for high and radio frequencies. This allows an evaluation of the sensor system prior to fabrication as well as optimization of the overall response.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.