Abstract
Reducing cycle times in the field of injection moulding demands that parts be ejected as soon as they are dimensionally stable. It is, therefore, imperative that the ejection forces be balanced and adequate so as to reduce the probability of part deformation. In this paper, we estimate ejection forces for moulded parts that have been used by the industry, and compare these models to simulation and experimental results for a simple cylindrical sleeve.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Modelling and Simulation in Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
