MODELLING AND 3D PRINTING OF JCB ARM

Abstract

The Hydraulic excavator machines are heavy duty earth movers consisting of a boom, arm and bucket. It works on principle of hydraulic fluid with hydraulic cylinder and hydraulic motors. The Hydraulic excavator arm operation require coordinated movement of boom, arm and bucket. The important criteria for the design to be safe is that, the digging forces developed by actuators must be greater than that of the resistive forces offered by the surface to be excavated. The main objective of this paper is to perform design and analysis Excavator Arm for the calculated Force. The CATIA software is used for making the 3D model of the excavator arm linkage. By using ANSYS workbench software analysis of the excavator arm is done at existing digging force and lifting force. Excavator bucket is very crucial element of hydraulic excavator. The whole loads of excavated materials have been carried out by this element. As the present mechanism used in excavator arm is subjected to deformation and bending stresses during lifting and digging operation respectively, because of which failure occurs frequently at the bucket end of the arm. Keywords: Excavator arm, Digging force, CATIA, ANSYS 16.0.