Modeling the thermal and hydrodynamic performance of grooved wick flat heat pipes

Abstract

A compact model is developed to predict the thermal and hydrodynamic performance of a flat heat pipe with a rectangular grooved wick. The present model relies on the analytical solution to the energy equation in the wall and an equivalent heat transfer coefficient predicted using a computationally efficient iterative method. This efficient iterative method can also provide a framework for modeling other grooved or porous wick heat pipes for which analytical or semi-analytical solutions to the wall conduction, fluid flow, and film equations exist. Compared to prior numerical tools, the present modeling approach is computationally efficient, making it compelling for use in parametric and optimization studies. Instead of numerically solving a set of coupled differential equations, the present model considers only analytical and semi-analytical solutions for evaporation and condensation heat transfer rates. The non-discretized nature of the present model allows computations on a typical workstation to be completed within seconds as opposed to the hours required for prevalent numerical tools. The present model accounts for varying liquid fill volumes, geometry, and interfacial properties, such as surface tension and contact angle. The present model closely agrees with published numerical and experimental results for wall temperatures and maximum heat transfer rates. Parametric studies, which vary wall thermal conductivity, water contact angle, and groove dimensions are conducted on a previously experimentally investigated heat pipe to demonstrate the present model’s capabilities. The present model found that the maximum heat transfer rate of the heat pipe can be enhanced by about 15 and 20% by varying its wetting angle and groove dimensions, respectively.