Modeling the Process of Obtaining Bars from Aluminum Alloy 01417 by Combined Rolling-Extruding Method with Application of the Deform-3D Complex

Abstract

The results of computer simulation of the process of combined rolling-extruding of longish deformed semi-finished products from alloy 01417 are presented. A feature of the research is that continuously cast bars with a diameter of 12.5 mm obtained using an electromagnetic mold are used as a workpiece. This makes it possible to increase the manufacturability of processing and to obtain after rolling-extruding billets for drawing with a diameter of 5 mm with a large resource of plastic and strength properties. For this case the technological parameters and temperature and speed conditions of combined processing have not yet been studied, therefore, their analysis was performed using the Deform-3D software package. It has been revealed that the feasibility of the rolling-extruding process is significantly affected by the frequency of rotation of the rolls. Moreover, the process becomes unstable when the value of this parameter is 4 rpm, which can be explained by insufficient degrees of deformation during rolling, and consequently by the small value of the active friction forces acting on the contact surface of the metal with the rolls. As a result of this, the processing temperature conditions also change, which is also demonstrated using the developed computer model. As a result, it was found that for the stable course of the combined rolling-extruding process at the CRE-200 unit of a continuously cast billet with a diameter of 12.5 mm from alloy 01417 at a heating temperature of the billet of 550 °C and a tool of 200 °C, degree of deformation during rolling 44% and drawing ratio during extruding 18.6 the frequency of rotation of the rolls should be at least 8 rpm. The simulation data used during the implementation of the process at the combined processing unit CRE-200, the results of which made it possible to finally obtain electrotechnical wire with a diameter of 0.5 mm from 01417 alloy that meets the requirements of TS 1-809-63-2018.