Modeling the electric field at interfaces and surfaces in high-voltage cable systems

Abstract

PurposeIn high-voltage direct current (HVDC) cable systems, space charges accumulate because of the constant applied voltage and the nonlinear electric conductivity of the insulating material. The change in the charge distribution results in a slowly time-varying electric field. Space charges accumulate within the insulation bulk and at interfaces. With an operation time of several years of HVDC systems, typically the stationary electric field is of interest. The purpose of this study is to investigate the influence of interfaces on the stationary electric field stress and space charge density.Design/methodology/approachAn analytic description of the stationary electric field inside cable insulation is developed and numerical simulations of a cable joint geometry are applied, considering spatial variations of the conductivity in the vicinity of the electrodes and interfaces.FindingsWith increasing conductivity values toward the electrodes, the resulting field stress decreases, whereas a decreasing conductivity results in an increasing electric field. The increased electric field may cause partial discharge, resulting in accelerated aging of the insulation material. Thus, interfaces and surfaces are characterized as critical areas for the reliability of HVDC cable systems.Research limitations/implicationsThis study is restricted to stationary electric field and temperature distributions. The electric field variations during a polarity reversal or a time-varying temperature may result in an increased electric conductivity and electric field at interfaces and surfaces.Originality/valueAn analytical description of the electric field, considering surface effects, is developed. The used conductivity model is applicable for cable and cable-joint insulations, where homo- and hetero-charge effects are simulated. These simulations compare well against measurements.