Abstract
A mechanical wear model for interactions between pad, wafer, and abrasives for surface removal during chemical mechanical polishing was developed. Effects of abrasive size distribution, surface softening, particle adhesion, and surface plastic deformation were included in the model. Interactions of particles that were trapped on the pad asperities with wafer surface were analyzed. Variations of surface hardness with the polishing time, down pressure, and relative velocity were also evaluated. Pads with wavy and random surface roughness were considered and model prediction results for dilute slurry concentrations were evaluated. Variations of the removal rate with down pressure, relative velocity, and surface hardness were analyzed. The results show that the surface removal rate decreases as abrasive size increases. Also for a constant relative velocity, the removal rate and the wafer surface hardness increase with increasing the slurry concentration and pressure. The results of the numerical simulations were compared with the available experimental data and good agreement was found.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.