Abstract
AbstractThe implementation of a Superconducting Magnetic Bearing (SMB) system is a promising solution for the problem of friction exhibited in the twisting elements of the conventional ring‐spinning process. This research focuses on the development of a dynamical model with six degrees of freedom of the Permanent Magnet (PM) ring used in an SMB system for a high‐speed ring spinning process. The modeling takes into account the magnetic forces and torques that enable the magnetic levitation of the PM ring. Experimental tests allow the identification of unknown parameters of the model and the validation is done through simulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
