Abstract
In order to understand critical vibrations of a drill bit such as stick-slip and bit-bounce and their wave propagation characteristics through a drillstring system, it is critical to model the torsional, longitudinal, and flexural waves. The objective is to model these waves propagating through the drillstring in a computationally efficient way. Here, a modeling method based on an acoustic transfer matrix between two sets of wave variables at the ends of a cylindrical pipe is proposed. For a drillstring system with multiple pipe sections, the total acoustic transfer matrix is calculated by multiplying all individual matrices of which each is obtained for an individual pipe section. Since drillstring systems are typically extremely long, conventional numerical analysis methods such as FEM require a large number of meshes, which makes it difficult to analyze these drillstring systems. On the contrary, the analytical acoustic transfer matrix method requires significantly low computational costs. For the validation, experimental and numerical data are obtained from a laboratory measurement and by using a commercial FEM package, ANSYS, respectively. They are compared to the modeling results obtained by using the proposed method. It is shown that the modeling results are well matched with the experimental and numerical results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.