Abstract
Modeling of the wear at the rear tool face in the turning of metals is based on an integral Volterra operator of the second kind. That permits adequate formal representation of tool wear in terms of the work and the power of irreversible energy transformations in the cutting zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.