Modeling of thermo-mechanical behavior of Ti-Ni shape memory alloy foils embedded in carbon fiber reinforced plastic laminates

Abstract

Ti-Ni shape memory alloy (SMA) foils are embedded into carbon fiber reinforced plastic (CFRP) cross-ply laminates in order to suppress the occurrence and progress of the transverse cracks in the laminates. When the pre-strained SMA foil is heated, the shape memory effect produces appropriate recovery compressive stress in the direction to suppress transverse cracks. However, Ti-Ni SMA foil has these specific characteristics due to the existence of a rhombohedral phase (R-phase). Thus, in this research, in order to use this SMA foil as an actuator, an extended Brinson model was proposed to clarify complicated behaviors of SMA. Then, for the determination of the parameters in the constitutive equation in this model, experimental tests were performed for the SMA foils. Using this model, several simulations were conducted and compared with experimental results. The agreement indicated that this model could express the thermo-mechanical behavior of the Ti-Ni SMA foil adequately. Finally, the behavior of the SMA foil during the CFRP manufacturing process was calculated on the basis of this model. The calculation results proved that the recovery stress already existed after the manufacturing process and the embedment of 4% pre-strained SMA into CFRP cross-ply laminate had the effect of suppressing the occurrence of transverse cracks.