Modeling of the inhomogeneity of grain refinement during combined metal forming process by finite element and cellular automata methods

Abstract

The potential of discrete cellular automata technique to predict the grain refinement in wires produced using combined metal forming process is presented and discussed within the paper. The developed combined metal forming process can be treated as one of the Severe Plastic Deformation (SPD) techniques that consists of three different modes of deformation: asymmetric drawing with bending, namely accumulated angular drawing (AAD), wire drawing (WD) and wire flattening (WF). To accurately replicate complex stress state both at macro and micro scales during subsequent deformations two stage modeling approach was used. First, the Finite Element Method (FEM), implemented in commercial ABAQUS software, was applied to simulate entire combined forming process at the macro scale level. Then, based on FEM results, the Cellular Automata (CA) method was applied for simulation of grain refinement at the microstructure level. Data transferred between FEM and CA methods included set of files with strain tensor components obtained from selected integration points in the macro scale model. As a result of CA simulation, detailed information on microstructure evolution during severe plastic deformation conditions was obtained, namely: changes of shape and sizes of modeled representative volume with imposed microstructure, changes of the number of grains, subgrains and dislocation cells, development of grain boundaries angle distribution as well as changes in the pole figures. To evaluate CA model predictive capabilities, results of computer simulation were compared with scanning electron microscopy and electron back scattered diffraction images (SEM/EBSD) studies of samples after AAD+WD+WF process.