Abstract
A model based on the thermodynamic and kinetic was conducted to simulate the Cr depletion profiles near the grain boundary in Inconel 600 during the heat treatments and laser surface melting (LSM) process using Thermo-Calc and Dictra code. Based on the good agreement of Cr concentration distribution during heat treatments measured by experiments, the microsegregation of Cr induced by cellular microstructure formed during the LSM process was also modeled. The Cr depletion profile was evaluated using the Cr depletion area below the critical Cr concentration for intergranular cracking/intergranular stress corrosion cracking (IGC/IGSCC) susceptibility (8 mass%). Comparing with the result of Streicher test, the Cr depletion area calculated showed good coherence with the IGC/IGSCC susceptibility. The sample after SR + LTS treatment with the largest Cr depletion area showed the worst IGC/IGSCC resistance, while, the sample after LSM process with the smaller Cr depletion area showed the excellent IGC/IGSCC resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.