Abstract
A mathematical model for the anionic polymerization of isoprene using n-butyl lithium (n-BuLi) as initiator and N,N,N′,N′-tetramethylethylenediamine (TMEDA) as microstructure modifier, considering a system similar to a tetrapolymerization and a scheme of reaction that considers that the active sites are different in configuration, has been developed. Experimental data of conversion versus time and structure development (1,4-cis, 1,4-trans, vinyl or isopropenyl units) were taken from the literature. Since 1,4-cis structural units are difficult to measure, directly, we used reports based on indirect measurements for natural polyisoprene. The cis structural unit fraction was varied from 0.1 to 0.9 (referred to cis+trans content) in order to provide enough data for parameter estimation purposes. Rate expressions for monomer consumption as well as microstructure and dyad development were obtained from the proposed scheme of reaction. The fraction of active sites and dyad distribution were calculated using Markov chains theory, based on conditional probabilities. The kinetic model correctly describes the performance anionic polymerizations with and without TMEDA.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.