Modeling of Failure Modes Induced by Plastic Strain Localization in Dual Phase Steels

Abstract

Microstructure level inhomogeneity between the harder martensite phase and the softer ferrite phase renders the dual phase (DP) steels more complicated failure mechanisms and associated failure modes compared to the conventionally used low alloy homogenous steels. This paper examines the failure mode DP780 steel and DP 980 steel under different loading conditions using finite element analyses on the microstructure levels. Micro-mechanics analyses based on the actual microstructures of DP steel are performed. The two-dimensional microstructure of DP steel was recorded by scanning electron microscopy (SEM). Mechanical properties of the ferrite and martensite phases exhibit the dependency of the different chemistry and thermal mechanical processes. The plastic work hardening properties of the ferrite phase was determined by the synchrotron-based high-energy X-ray diffraction technique. The work hardening properties of the martensite phase were calibrated and determined based on the uniaxial tensile test results. Under different loading conditions, different failure modes are predicted in the form of plastic strain localization. The local failure mode was closely related to the stress state in the material. Under plane stress condition with free lateral boundary, one dominant shear band develops and leads to final failure of the material. However, if the lateral boundary was strictly constrained,more » splitting failure perpendicular to the loading direction is predicted. On the other hand, under plane strain loading condition, commonly observed necking phenomenon is predicted which leads to the final failure of the material. Numerical predictions were well validated by the experimental.« less