Abstract
<p>Enhancing the performance of high-pressure LDPE process is valuable for polymer industry. However, the severe thermodynamics requirement of high pressure and temperature hinders the reaction process from getting simultaneously high monomer conversion and polymer molecular weights. Bifunctional peroxides used as initiators can boost the polymerization rate and alter rheological polymer properties. This article proposes a new kinetics model of ethylene/butyl acrylate copolymerization with bifunctional initiators in a high-pressure nonisothermal tubular reactor. Model predictions are compared with available data. A SQP optimization scheme is employed to determine a suitable wall temperature for each zone along the nonisothermal tubular reactor. In comparison with the monofunctional TBPPI peroxide, a lower amount of the bifunctional DHBPPI peroxide is needed to get a higher conversion in shorter residence time, but at the expense of higher thermal energy. The results also showed that polymers produced with bifunctional peroxides are significantly more branched. </p>
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.