MODELING OF CREEP PROCESSES OF SINGLE-CRYSTAL ALLOYS WITH TAKING INTO ACCOUNT OF RAFTING

Abstract

The research is devoted to the development and verification of a two-level micromechani-cally motivated model of viscoelastic deformation of two-phase nickel-based single-crystal al-loys, predicting behavior under high thermomechanical loading with taking into account the presence of γ and γ' phases. The model is relevant for computations of the stress-strain state of cooled single crystal blades of gas turbine units. The formulation of the constitutive equations for each of the phases considered the anisot-ropy of elastic and viscous properties, the presence of octahedral slip systems, the features of the cubic system, and the presence of viscous properties both below and above the yield stress. Model parameters for γ and γ' phases were identified based on known creep curves for each phase. The effective properties of a single-crystal alloy, considering the presence of γ and γ' phas-es, were determined both based on finite element homogenization for a representative volume and using the simplest rheological (structural) models of the material, considering the series and parallel connection of phases. Based on multivariant computational experiments and analytical estimates, the dependences of the viscoelastic properties of nickel-based single-crystal alloys on the volume fraction of the γ' phase are determined. Phenomenological creep models that take into account the change in the volume fraction and the morphology of γ' inclusions have been proposed. The simulation results using the proposed two-level microstructural model of the material demonstrate a good agreement with the experimental data for the ZhS32 single-crystal heat-resistant alloy.