Modeling of complex multi-aquifer systems for groundwater resources evaluation—Swidnica study case (Poland)

Abstract

An example of groundwater resources evaluation methodology by numerical modeling in the complex, unconsolidated, multi-aquifer system of the Swidnica area (~627 km2) is presented. In this study Groundwater Modeling System (GMS) was used to develop a conceptual model on the basis of data from several hundred boreholes and to calibrate a numerical, multi-aquifer model. A steady state calibration was performed using historical natural groundwater table (quasi-natural simulation) data and abundant pumping test transmissivity data. The calibrated recharge was first spatially distributed based on surface lithology and then adjusted until a good match between calculated and measured heads was obtained. The quasi-natural simulation budget input of ~165,000 m3/day consisted of 40.5% of lateral inflow from the SW fault model boundary, 34.5% of average net recharge from precipitation, 13% of infiltration from the Mietkowskie Lake and 12% of river infiltration. The budget output (the same as input) consisted of ~ 88% of river drainage and ~ 12% of lateral outflow. The final, abstraction-influenced simulation representing the current stationary condition was used to verify the model by cross referencing present well drawdowns with well abstractions and by comparison of the groundwater discharge to the rivers with the field baseflow measurements. In this simulation, the total well abstraction of ~53,000 m3/d resulted in 9% increase in overall water balance up to ~180,000 m3/day, 38% increased river infiltration, 24% reduced river drainage, 17% reduced lateral outflow and ~3 times increased downward leakage to the deepest, productive aquifer.