Abstract
The present work is aimed at optimizing the parameters of micro Wire Electric Discharge Machining (µ-WEDM) process by considering the simultaneous effects of input parameters viz: gap voltage, capacitance and feed rate. Experiments were planned and conducted using DoE techniques. ANOVA was performed to find out the significance of each factor. Regression models were developed for the experimental results of surface roughness and overcut of the micro slots produced on aluminium. Then Genetic Algorithm (GA) was employed to determine the values of optimal process parameters for the desired output value of micro wire electric discharge machining characteristics.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
