Abstract
This paper presents the process of a motion control system design and implementation for a teleminulation system. The robotic manipulator/hand is a nonlinear system with coupled effects among the joints. By applying the frequency response method, the nonlinear system is modeled as decoupled linear ones, in which each joint is controlled independently. The experimental results show the feasibility of the modeling process. Based on the obtained transfer function of each joint, the digital PID controllers are designed. The motion control system for the telemanipulation system is then implemented using the software package MATLAB, Simulink, Real Time Workshop, xPC Target and a C/C++ compiler, and the hardware I/O boards, amplifiers, etc. The presented developing procedure shows a convenient way to implement a real time robotic control system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Software Engineering and Knowledge Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
