Modeling and Control of Real Flow Calibration System

Abstract

Abstract The calibration of large-diameter flow meters is performed in the calibration station where real flow passes through. The typical calibration process is manipulated by human operators, which is time-consuming and easily affected. Since most of the process parameters are detectable, the smart calibration system was aided by the on-line modeling process and consisted of three parts: the digital twin model, the process controller, and the human-machine interface (HMI). The digital twin model was based on the basic partial differential equations of the gas flow in pipelines and was meant for the flow behavior prediction over short periods and provided decision-making assistance for human operators. The verification of the digital model was based on both the historical process data and the real-time process data. The process controller represented the manipulator meant to replace the human operator. The function of the controller included process control and calibration flow point adjustment. The HMI was designed based on the industrial supervisory control and data acquisition (SCADA) system. Since the process control was essential, the scheduling scheme and command sequence feedback to the SCADA system was rechecked by human operators via the HMI. The result of the active control was displayed in the HMI based on the digital twin model. Since smart control was the tendency in the piping system, the automated process verification and control formed the basis of the smart system. By entering the size and range of the flow meters into the HMI, the entire industrial system inside the calibration station was executed automatically.