Model simulation of gravity waves triggered by a density current

Abstract

AbstractIn this study, starting from an observational case of internal gravity waves (IGWs) generated at the top of a drainage flow during the SABLES2006 field campaign, we aim to reproduce the IGWs and their origin through mesoscale meteorological modelling. We used the Weather Research and Forecast (WRF) model with fine horizontal resolution (1 km), testing the model capabilities to simulate the IGWs through a WRF fixed physics package option but two different planetary boundary layer schemes, the Mellor‐Yamada‐Janjić (MYJ) and the Yonsei University (YSU). The comparison between model simulations and measurements from a 100 m meteorological tower reveals that the MYJ scheme simulation gives much better results, as it better represents the main features of the density current measured by the tower instruments, although the event is predicted to occur sooner than it is observed to occur. The study has also shown the capacity of this scheme to detect the oscillations in temperature and specific humidity generated by the arrival of the density current. In contrast, the YSU scheme captures the arrival of the current on time but it fails to correctly track its properties and therefore it does not reproduce the gravity waves with the current arrival. In addition, wave parameters calculated from model outputs (MYJ) using the wavelet method reveal waves with longer periods and longer wavelengths (T = 20–22 min and λ = 8–10 km) than those calculated from measurements (T = 9.2 min and λ = 3.5 km) using the same technique. Copyright © 2012 Royal Meteorological Society