Abstract
This paper presents an original model developed by finite element method to simulate the behavior of the material to the method “Blind Hole Drilling”, to determine the residual stress. Modeling of this method is possible through the use of the “Birth and Death” which have some elements of ANSYS library. After obtaining the analysis of movements, appropriate loads, a node located from the center hole at a radius calculated. In this way it is easier to estimate the stresses and deformations of a piece. Several measurements are made and based on this model is given in ANSYS. In this way we can have a map of tensions and deformations in a material
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
