Abstract
Tuned mass dampers (TMD) are an established method to reduce self-excited chatter vibrations in turning. Regarding boring bars, the susceptibility to chatter increases with increasing length and, even more, with decreasing tool diameter.A novel TMD for boring bars with diameters down to 10mm is presented. The TMD-design, consisting of a mass and a spring-damper combination, is based on analytical and numerical modelling. By using a futed boring bar design, the available design space allows to place a damping mass of sufcient mass ratio at the tool tip. Cutting tests showed the reduction of vibrations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.