Mode I, mode II, and mixed-mode I/II interlaminar fracture toughness of GFRP influenced by fiber surface treatment

Abstract

The interlaminar fracture behavior of unidirectional glass fiber reinforced composites with fiber surface treatment has been investigated in modes I and II and for fixed mode I to mode II ratio of 1.33. The data obtained from these tests have been analyzed by using different analytical approaches. The present investigation is focused on the influence of the glass fiber surface treatment on the interlaminar fracture toughness of unidirectional laminates. Glass fibers with two different fiber surface treatments have been investigated. fiber surface treatment was carried out by using a polyethylene or silane coupling agent in combination with modifying agents. The glass fibers were embedded in the brittle epoxy matrix. Mode I, mode II, and mixed-mode I/II tests were performed in order to determine critical strain energy release rates. Double cantilever beam (DCB), end-notched flexure (ENF), and mixed-mode flexure (MMF) specimens were used. For both types of fiber surface treatment about the same values of mode I initiation fracture toughness GIC init were obtained. It was observed that in mode I interlaminar crack growth in the DCB test for the composite sized by polyethylene, the crack propagation is accompanied by extensive fiber bridging. For both fiber surface treatments interlaminar fracture toughness increases considerably with increasing of crack length. For the fiber surface treatment with the silane coupling agent, the value of mode II initiation fracture toughness GIIC init was about 2.5-times higher in comparison with that of a composite sized by polyethylene. For both types of fiber surface treatments the mixed-mode I/II test has shown a similar behavior to the mode I DCB test.