Mode Division Multiplexed 850-nm Single-Mode VCSEL Transmission Using Standard Single-Mode Fiber

Abstract

Listen

Translate article

Mode division multiplexing (MDM) has attracted great attention in recent years to increase the network capacity. To apply MDM in data center applications, a low-cost and low power consumption system is desired. In this letter, we utilize 850-nm single-mode VCSEL as the laser source and report mode division multiplexed transmission over a standard single-mode fiber, which is two-mode at 850 nm. Due to the small spot size and low numerical aperture, single-mode VCSEL can be coupled into single-mode fibers with low loss. The mode multiplexer and de-multiplexer devices are designed and fabricated based on fiber mode selective couplers using Hi780 fiber as the 850-nm single-mode launch and receiving fiber and standard single-mode fiber as the few-mode transmission fiber. The MDM system supports two channels, corresponding to the LP <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">01</sub> and LP <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">11</sub> mode in the few-mode transmission fiber. Detailed characterizations of the multiplexer and de-multiplexer are conducted including the insertion loss and crosstalk measurements. System transmission at 25 Gb/s shows error free performance over 1-km standard single- mode fiber for both channels. The utilization of VCSEL and standard single-mode fiber can potentially provide a low-cost solution for MDM systems in data center applications.