MnS Precipitation Behavior of High-Sulfur Microalloyed Steel Under Sub-rapid Solidification Process

Abstract

A typical high-sulfur microalloyed steel was investigated by a sub-rapid solidification process for grain refinement of the as-cast microstructure. The size and distribution characteristics of the MnS precipitates were analyzed. The variations in the dendrite morphology and secondary dendrite arm spacing (SDAS) under different cooling rates have been studied, which strongly influence the precipitation behavior of MnS. The 3D-morphology of MnS precipitates was revealed by a novel saturated picric acid deep-etching method. Most MnS precipitates with a length smaller than 5 μm were columnar or equiaxed in the corresponding dendrite zones under sub-rapid solidification conditions at cooling rates of 261 to 2484 K/s. Furthermore, an area scan analysis of the precipitates showed the number of small MnS per square millimeter with lengths lower than 3 μm decrease from 200,537 to 110,067. The percentage of large MnS with a length over 5 μm increased from 2.6 to 6.2 pct as the solidification condition changed from sub-rapid to air cooling. In addition, the size of MnS precipitate was found to depend linearly on the SDAS.