Abstract

Abstract. The variability of the mixing state of refractory black carbon aerosol (rBC) and the corresponding complicated light absorption capacity imposes great uncertainty for its climate forcing assessment. In this study, field observations using a single-particle soot photometer (SP2) were conducted to investigate the mixing state of rBC under different meteorological conditions at a rural site on the North China Plain. The results showed that the hourly mass concentration of rBC during the observation periods was 2.6±1.5 µg m−3 on average, with a moderate increase (3.1±0.9) during fog episodes. The mass-equivalent size distribution of rBC exhibited an approximately lognormal distribution with a mass median diameter (MMD) of 213 nm. We found that the count median diameter (CMD) of rBC particles during snowfall episodes was larger than that before snowfall, and the number of rBC particles with Dc<121 nm were reduced by 28.4 % after snow. This may indicate that rBC-containing particles with small core sizes (Dc) were much more effectively removed by snow with light snow intensity (0.23 mm h−1). Based on the Mie scattering theory simulation, the relative and absolute coating thicknesses of rBC-containing particles were estimated to be ∼1.6 and ∼52 nm for the rBC core with a mass-equivalent diameter (Dc) of 170 to 190 nm, respectively, which indicates that most of the rBC-containing particles were thinly coated. Furthermore, a moderate light absorption enhancement (Eabs=1.3) and relatively low absorption cross section (MAC = 5.5 m2 g−1) at 880 nm were observed at the Gucheng (GC) site in winter compared with other typical rural sites. The relationship between the microphysical properties of rBC and meteorological conditions was also studied. Relatively warm and high-RH environments (RH>50 %, -4∘C<T<4∘C) were more favorable to rBC aging than dry and cold environments (RH<60 %, T<-8∘C). And the increase in ambient RH at the same temperature favors rBC aging. An increasing mass fraction of secondary inorganic aerosols (SIAs; especially sulfate and nitrate) and a decreasing mass fraction of organic aerosols in the environment support the formation of thick coatings by rBC. The RH dependence of absorption enhancement (Eabs) was likely caused by the relative coating thickness (RCT) as supported by the gradual increase in the mass concentration and mass fraction of secondary components as a function of RH in the ambient air. The mass fractions of aqueous-phase formation of secondary components had a limited effect on Eabs under a high-RH environment. The measured rBC concentrations and the mixing state of rBC in different meteorological environments will be useful for evaluating the radiative forcing of rBC in regional climate models.

Highlights

  • As an absorbing aerosol produced by incomplete combustion, black carbon plays a leading role in the absorption of shortwave solar radiation and changes atmospheric thermodynamics through the heating effect

  • Using a transmission electron microscope fitted with an environmental cell (ETEM), we observed that fresh black carbon presents a loose and porous chain structure, and in the atmosphere through condensation, coagulation, heterogeneous oxidation condensation, or heterogeneous chemical reaction, refractory black carbon aerosol is coated by soluble material, and the coating gradually becomes thicker with increasing relative humidity (RH) (He et al, 2015; Freney et al, 2010)

  • The size distribution, coating thickness, and optical properties of individual refractory black carbon aerosol (rBC)-containing particles were measured by a single-particle soot photometer (SP2) during the period 7 to 31 December 2019 to characterize the mixing state of rBC-containing particles in rural areas on the North China Plain

Read more

Summary

Introduction

As an absorbing aerosol produced by incomplete combustion, black carbon plays a leading role in the absorption of shortwave solar radiation and changes atmospheric thermodynamics through the heating effect. Wet removal is a key factor in determining the lifetime of black carbon aerosols in the atmosphere, which determines their vertical and horizontal distribution, local and regional diffusion, and direct, semidirect, and indirect radiative forcing effects (Liu et al, 2013). It has been shown that the mixing of BC and other non-BC materials can enhance radiation absorption, which is interpreted as exhibiting a “lensing effect,” with the magnitude strongly dependent on the rBC coating amount (Cappa et al, 2012; Liu et al, 2015; Moffet and Prather, 2009). The change in the mixing state of black carbon aerosols and their driving factors are not clear under highpollution and RH conditions

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call