Mixed model for the analytical determination of critical buckling load of passive reinforcement in compressed RC and FRC elements under monotonic loading

Abstract

Compressed reinforcements on reinforced concrete (RC) and steel fibre reinforced concrete (SFRC) columns are generally submitted to cyclic and monotonic loading, which can buckle. This phenomenon can cause the reduction of both ductility and peak loads, which is why design standards propose constructive details to avoid this. Although the bibliography mentions that steel fibres in concrete can delay buckling of reinforcements, design codes do not distinguish between concrete types (with and without fibres) in these constructive details. Analytical models that determine the length and critical buckling stress of reinforcements may consider this effect. Nowadays, analytical models can be classified as discrete and distributed depending on whether they consider transverse reinforcement stiffness and the stiffness of the concrete cover that concentrates on transverse reinforcements, or if they are distributed along the element, respectively. Both discrete and distributed models are valid for small transverse reinforcement separations, while distributed models that only consider the concrete cover effect are valid for large transverse reinforcement separations.This paper proposes a mixed model to determine critical buckling loads of compressed reinforcements subjected to monotonic loading to use the stress-strain relationships of reinforcing bars, including buckling, that are found in the scientific-technical literature. This model considers transverse reinforcements discretely and concrete cover distributedly. The model can be applied to any transverse reinforcement configuration, and to any concrete type (with or without fibres). An analytical equation is also proposed to determine critical compressed reinforcement loads, whose result is presented as abaci. Finally, to calibrate the model in normal-strength concrete columns under eccentric loading, with or without fibres, a programme is presented in which the critical load of longitudinal reinforcements is experimentally determined. The proposed analytical model is calibrated and a procedure to determine critical buckling loads of compressed reinforcements under monotonic loading is proposed.