Abstract
An aqueous suspension of cellulose nanocrystals (CNCs) was prepared by acidic hydrolysis of microcrystalline cellulose to be used as a nonsolvent in the fabrication of polyethersulfone (PES) membranes via the phase inversion method. The effect of CNC concentration on the membrane permeability, surface morphology and antifouling capability was probed. Also, the efficiency of adding nanocrystals to the nonsolvent for two different concentrations of PES dope solution was examined. The coagulation of PES in the presence of CNCs led to a more hydrophilic and smoother surface as well as higher bulk porosity. The thin skin layer and more porous membrane suggested higher water flux for CNC-treated membranes. Due to the hydrophilic nature of CNCs trapped in the membrane top layer, a superior antifouling ability was found for membranes precipitated in 0.1 wt% CNCs aqueous suspension. The concentration of the CNC suspension had a more significant influence on the permeability of membranes prepared by the dope solution with a low content of PES rather than highly concentrated one.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
