Mitigating Rotor Movement During Estimation of Flux Saturation Model at Standstill for IPMSMs and SynRMs

Abstract

This article proposes a novel method to reduce rotor movement when estimating magnetic flux models for interior permanent magnet synchronous motors (IPMSMs) and synchronous reluctance motors (SynRMs). A rotation reduction technique that considers the flux saturation effect is proposed. A hysteresis controller is used to inject voltages only into the <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">q</i> -axis and simultaneously into the <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">dq</i> -axes. The rotation of the IPMSM is reduced by calculating the current at the point where the integral of the <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">q</i> -axis current over time becomes zero. In the case of SynRM, the rotation is reduced by calculating the injection voltage magnitudes such that the oscillation frequency of the <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">q</i> -axis current is higher than that of the <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">d</i> -axis current. The effectiveness of the proposed method was experimentally demonstrated using an 11-kW IPMSM and 1.5-kW SynRM. The proposed technique can be used for the self-commissioning of IPMSMs and SynRMs at a standstill, without rotor locking, or position sensors.