Mitigating laser imprint with a foam overcoating

Abstract

In direct-drive inertial confinement fusion, laser imprint can cause areal density perturbations on the target shell that seed the Rayleigh–Taylor instability and further degrade the implosion. To mitigate the effect of laser imprint, a foam overcoating layer outside the target shell has been suggested to increase the thermal smoothing of the conduction region (between the ablation front and the critical density surface) and mass ablation of the ablation front. In this paper, we use a two-dimensional radiation hydrodynamic code FLASH to investigate the laser imprint mitigation performance and find other physical mechanisms of foam overcoatings. First, radiation ablation dynamically modulates density distribution not only to increase the frequency of the perturbed ablation front oscillation but also to decrease the amplitude of the oscillation. Second, a larger length of the shocked compression region reduces the amplitude of the perturbed shock front oscillation. The areal density perturbations decrease with the decrease in the perturbations of the ablation front and shock front. Based on the abovementioned physical mechanisms, we propose the optimal ranges of foam parameters to mitigate laser imprint with the aid of dimensional analysis: the foam thickness is about two to three times that of the perturbation wavelength, and the foam density is about 1/2–3/2 times that of the critical density.