Miscible N2 EOR in a Giant High Temperature Complex Carbonate Reservoir

Abstract

Abstract In this paper, we investigate the potential for applying miscible nitrogen injection as an enhanced oil recovery (EOR) method for a high-temperature, low-permeability carbonate reservoir, which contains a volatile oil with some H2S and CO2. The field, which is located onshore Abu Dhabi, is still in its early development phases but suffers from relatively low throughput rate because of low permeability. Various gas injection schemes are being considered, with different source gases. At the prevailing reservoir pressures, extensive phase behavior studies confirm that the reservoir fluids develop miscibility with nitrogen, carbon dioxide, and hydrocarbon gas. The simulation studies involve a number of sensitivity runs performed on sector models, which are sufficiently fine-gridded to capture the compositional transition zone propagating between injector and producer pairs. Miscible nitrogen injection comes out as a viable option with the potential to increase recovery by 10 to 20% above the current water flood development scheme. The significantly improved sweep and displacement efficiency are due to N2 miscibility with reservoir oil under reservoir conditions, possibility of increased PV injected in a N2 WAG scheme, and the ability to maintain a higher reservoir pressure (at initial reservoir pressure). From a surface facilities point of view, techniques for N2 capturing is mature, tried and tested. N2 being inert does not pose corrosion risks to well completion and surface facilities. However, capital costs for N2 rejection units – if utilised in a N2 WAG EOR scheme – will need to be taken into account. Although N2 WAG EOR is seen to be very attractive for the reservoir under study, alternative EOR schemes are also being actively evaluated. The aim is to arrive at an optimum EOR project for the reservoir in line the achieving the 70% oil recovery aspiration.