Minimise System Upsets in High Oil Production Facility throughout Demulsifier Chemical Trial

Abstract

Abstract Process upsets in high oil production facilities can hinder optimal plant performance and result in system shut-ins. Based on several successful demulsifier chemical trials, scientists and engineers have developed a guideline on how to optimize production throughout the chemical trial period. Factors such as chemical injection rate, export crude oil monitoring (basic sediment and water (BS&W) and salt), discharge water quality(from the water-oil separator (WOSEP)), and transformer voltage fluctuation (dehydrator and desalter) plays an important role in minimizing the system upset. Prior to chemical trial, scientists and engineers analyze the process system to understand individual vessel functions and limitations. Incumbent chemical program provides baselines and key performance indicators (KPIs) set minimum oil specifications before exporting oil to refineries. Demulsifier injection rates are reduced based on the chemical program optimization proposal until it reaches the dosage limit while maintaining stable process throughout the trial. Therefore, scientists and engineers may evaluate the demulsifier’s performance based on the KPIs set with no system upset. Fast fluid separation in the High Pressure Production Traps (HPPTs) is an important strategy in order to improve process system’s performance. High volume oil production systems typically have two HPPTs in parallel for initial water separation. Downstream of the HPPTs is the Low Pressure Production Trap (LPPT), which is mainly used for gas separation. Oil continues to the dehydrator to finish the dehydration to meet the pipeline BS&W requirement. The dehydrator is where the transformer is located for the electrostatic grid and high amounts of water separation can cause fluid levels to fluctuate and trip the transformers. Throughout several field trial experiences, demulsifier rates can be optimized (reduced) further when it shows increased water separation at HPPT vessels. Clear water from HPPTs discharge, valves in water leg HPPTs open more (%), stable voltage grid (dehydrator/desalter), and less than 0.2% BS&W with less than 10ptb salt recorded at the export oil gives a good indication that the process is stable. Thus reduced the risk for system upset. This paper summaries the best approach to optimize chemical rates in high volume oil production systems, analyzes qualitative and quantitative system checks to verify stable operations, and discusses potential risks involved when reaching lower limits of effective chemical rates.