Mini-iFT Confirms Superior Adhesive Luting Performance using Light-curing Restorative Composites.

Abstract

To validate the rationale of using a conventional light-curing resin-based composite (RBC) to lute thick indirect restorations by measuring mini-interfacial fracture toughness (mini-iFT). Freshly exposed dentin of extracted third molars (n = 64) was immediately sealed with a thin layer of an experimental RBC with a 50 wt% or 75 wt% (IDS) filler load. Two- or 6-mm-thick CAD/CAM composite blocks were luted onto IDS using either pre-heated light-cure or dual-cure luting RBC, with the latter having served as control. Samples were cut into sticks, upon which a notch was prepared at the interface between IDS and luting RBC, prior to being submitted to a 4-point bending test to determine mini-iFT. The results were analyzed using a mixed linear model (LME). Failure mode at the fractured interface was determined using scanning electron microscopy (SEM). LME revealed that mini-iFT was not significantly affected by the composite block thickness (p = 0.39), but by the luting RBC (p < 0.0001) and the IDS RBC filler load (p = 0.0011). Mini-iFT was higher with 50 wt% filler-loaded RBC IDS and when luted using the light-curing RBC. This work provides the proof of concept that 2- and 6-mm-thick indirect restorations can safely be adhesively luted with pre-heated conventional light-cure RBC under controlled light-irradiation conditions. This strategy even seems beneficial in terms of mini-iFT compared to using a dual-cure luting RBC. IDS with lower filler content also appeared more favorable.