Abstract
With the development of aerospace, biomedical and chemical industries, titanium alloy Ti-5Al-5Mo-5V-1Cr-1Fe (TC18) is becoming widespread used. TC18 has even better mechanical property than Ti-6Al-4V (TC4). For better cutting TC18, simulation model was set up. PVD and CVD coated carbide inserts were used to machine titanium alloy TC18. The cutting forces were measured. Milling model was set up for the extraction of the cutting force coefficients and chip flow angle. Results were compared. All the coefficients of CVD coated carbide insert were found to be larger than those of PVD coated carbide insert. The model was proved to be reasonable after validation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.