Milk pH as a Function of CO2 Concentration, Temperature, and Pressure in a Heat Exchanger

Abstract

Raw skim milk, with or without added CO2, was heated, held, and cooled in a small pilot-scale tubular heat exchanger (372ml/min). The experiment was replicated twice, and, for each replication, milk was first carbonated at 0 to 1°C to contain 0 (control), 600, 1200, 1800, and 2400ppm added CO2 using a continuous carbonation unit. After storage at 0 to 1°C, portions of milk at each CO2 concentration were heated to 40, 56, 72, and 80°C, held at the desired temperature for 30s (except 80°C, holding 20s) and cooled to 0 to 1°C. At each temperature, five pressures were applied: 69, 138, 207, 276, and 345 kPa. Pressure was controlled with a needle valve at the heat exchanger exit. Both the pressure gauge and pH probe were inline at the end of the holding section. Milk pH during heating depended on CO2 concentration, temperature, and pressure. During heating of milk without added CO2, pH decreased linearly as a function of increasing temperature but was independent of pressure. In general, the pH of milk with added CO2 decreased with increasing CO2 concentration and pressure. For milk with added CO2, at a fixed CO2 concentration, the effect of pressure on pH decrease was greater at a higher temperature. At a fixed temperature, the effect of pressure on pH decrease was greater for milk with a higher CO2 concentration. Thermal death of bacteria during pasteurization of milk without added CO2 is probably due not only to temperature but also to the decrease in pH that occurs during the process. Increasing milk CO2 concentration and pressure decreases the milk pH even further during heating and may further enhance the microbial killing power of pasteurization.