Abstract
A new measurement technique for determining the broadband driving point impedance of large two-dimensional active grid arrays is presented. The active array radiates a plane wave in the broadside direction when all elements are locked in phase. For analysis, the array is reduced to a single unit cell by exploiting the array symmetries. The driving point impedance of the unit cell is determined by using the dielectric waveguide measurement method (DWM). The approximations of the method are discussed, and the method is compared with other measurement techniques. Results are presented for four square arrays: dipole, bow-tie, double-vee and slot array. The measurement method is verified by comparing it to the full-wave theory in the whole range. It is shown that all four antenna arrays can be represented by very simple circuits that use only transmission lines as circuit elements. The bow-tie array is found to represent the best choice for broadband operation.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">></ETX>
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
