Abstract
The effects of sintering aid addition on the microstructures and microwave dielectric properties of La(Mg 1/2Ti 1/2)O 3 ceramics were investigated. CuO was selected as liquid phase sintering aid to lower the sintering temperature of La(Mg 1/2Ti 1/2)O 3 ceramics. With CuO addition, the densification temperature of La(Mg 1/2Ti 1/2)O 3 can be effectively reduced from 1600 to 1300–1500 °C. It is found that doping of CuO (1–4 wt%) can significantly improve the density and dielectric properties of La(Mg 1/2Ti 1/2)O 3 ceramics. Second phases were observed at the level of 1–4 wt% CuO additions. The quality factor Qxf was strongly dependent upon the amount of additions. Qxf values of 33,800 and 10,600 GHz could be obtained at 1300–1500 °C with 1 and 4 wt% CuO addition, respectively. During all addition ranges, the relative dielectric constants were different and ranged from 25.89 to 29.63. The temperature coefficient varies from −52.11 to −68.22 ppm/°C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.