Microtransfer printing of metal ink patterns onto plastic substrates utilizing an adhesion-controlled polymeric donor layer

Abstract

We propose a method for transfer-printed electrode patterns onto flexible/plastic substrates, specifically intended for metal ink that requires a high sintering temperature. Typically, metal-ink-based electrodes cannot be picked up for microtransfer printing because the adhesion between the electrodes and the donor substrate greatly increases after the sintering process due to the binding materials. We introduced a polymeric donor layer between the printed electrodes and the donor substrate and effectively reduced the adhesion between the Ag pattern and the polymeric donor layer by controlling the interfacial contact area. After completing a wet-etching process for the polymeric donor layer, we obtained Ag patterns supported on the fine polymeric anchor structures; the Ag patterns could be picked up onto the stamp surface even after the sintering process by utilizing the viscoelastic properties of the elastomeric stamp with a pick-up velocity control. The proposed method enables highly conductive metal-ink-based electrode patterns to be applied on thermally weak plastic substrates via an all-solution process. Metal electrodes transferred onto a film showed superior electrical and mechanical stability under the bending stress test required for use in printed flexible electronics.