Abstract
Micro-thermal field-flow fractionation (μ-TFFF) was applied to the separation of polystyrene latices. This new high-resolution technique allows determination of the particle size distribution (PSD) if carried out under optimized experimental conditions. The optimum temperature of the accumulation wall, which influences the relaxation processes and, consequently, the zone broadening, was chosen on the basis of our prior work. The flow rate was chosen as a compromise between the theoretical optimum value, which is very low because the diffusion coefficients of the colloidal particles are very small, and a value allowing performance of the PSD analysis in a reasonable time. These experimental conditions can be manipulated easily due to the high versatility of μ-TFFF, which follows from a large decrease of the heat energy flux across the channel with its reduced dimensions in comparison with standard TFFF. The PSDs obtained from μ-TFFF data are compared with results from quasi-elastic laser light scattering (QELS) and transmission electron microscopy (TEM). It has been found that a baseline resolution of a model mixture of two samples of close average particle diameters can be achieved by an appropriate choice of the temperature drop in μ-TFFF, whereas only a broad, unresolved PSD of the mixed sample was obtained from the QELS measurement. The TEM of the mixed sample revealed the presence of two particle size populations. However, the number of particles which are practically counted on a TEM picture is several orders of magnitude lower than the number of particles taken into account in μ-TFFF or QELS. Consequently, the PSD obtained from the TEM did not represent the whole sample. Comparison of μ-TFFF with modern hydrodynamic chromatography (HC) has shown that the methods exhibit roughly the same resolution and time of analysis. Nevertheless, μ-TFFF is a more universal technique because the separation of the colloidal particles or of the macromolecules within a broad range of molar masses is carried out on the same channel, as demonstrated previously.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.