Abstract
Commercial FeAl powders and ZrO 2 nano-particles as well as CeO 2 additive were reconstituted into a novel multi-compositional feedstock powders via spray drying. The resulting feedstock powders were used to deposit FeAl/CeO 2/ZrO 2 nano-composite coating by plasma spraying on 1Cr18Ni9Ti stainless steel. An X-ray diffractometer (XRD), a scanning electron microscope equipped with an energy dispersive spectrometer (SEM/EDS), and a field emission scanning electron microscope equipped with an energy dispersive spectrometer (FESEM/EDS) were employed to characterize the microstructure of the as-prepared feedstock powders and nano-composite coating. At the same time, the mechanical properties and friction and wear behavior of the nano-composite coating and pure FeAl coating were comparatively evaluated by using a Vickers microindentation tester and ball-on-disk sliding wear tribotester, respectively. And the wear mechanisms for the two types of coatings are discussed in terms of their microstructure and mechanical properties. Results indicate that the nano-composite coating has a much higher hardness and fracture toughness as well as drastically increased wear resistance than pure FeAl coating, which could be mainly attributed to the reinforcing effect of ZrO 2 nano-particles and partially attributed to the refining effect of CeO 2 in the nano-composite coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
