Abstract
The NiCrBSi/WC biomimetic coatings were prepared on the low carbon steel substrate by plasma spray welding with mixed powders (WC-Co12+NiCrBSi) based on the bionic principles, and the coating characteristics were investigated. The results indicate that the coatings have a full metallurgical bond in coating/substrate interface, and consist mainly of γ-Ni, WC, Cr23C6, Cr7C3, Ni3Si, Cr5B3, and FeNi3 phases. The powder composition influences the microstructures and properties of the coatings. The WC content and the hardness of coatings increase with the mass fraction of WC-Co12 powder. The biomimetic coatings have much higher wear resistance compared with the low carbon steel, which is attributed to the combination of hard WC and chromium carbide particles (bionic units) and soft γ-Ni matrix in the coatings. It is favorable to prepare the biomimetic coating by plasma spray welding with the mixed powders (20wt%WC-Co12+80wt%NiCrBSi) for improving the wear resistance of the coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
