Microstructure, Precipitates Behavior, and Mechanical Properties of Age-Hardened Al-Mg-Si Alloy Sheet Fabricated by Twin-Roll Casting.

Abstract

Twin-roll casting (TRC), as a near-net-shape technology, is employed to fabricate age-hardened Al-Mg-Si alloy. Compared with conventional direct chill (DC) casting, the TRC method is much more economical and efficient. In this work, the microstructure, precipitates behavior, and mechanical properties of age-hardened Al-Mg-Si alloy sheet fabricated by TRC were investigated by hardness measurements and tensile tests, metallographic microscopy, field emission gun scanning electron microscope, electron backscatter diffraction, transmission electron microscopy, and differential scanning calorimetry analyses. It was found that the size of recrystallized grains for DC casting alloy with finely dispersed particles was larger than that of TRC alloy with coarse particles. Typical CubeND texture accompanied by P texture formed after solution treatment made the value of r reach ~0.7 in the TRC alloy due to the PSN effect caused by the segregation of particles. More GP zones resulted in the strength of TRC alloy being higher than that of DC casting alloy after T8X treatment. With the time of paint-bake hardening extended to 8 h, few segregation particles remained in the TRC alloy. This decreased the concentration of supersaturated atoms. The hardness of the TRC alloy with the lower density of the β″ strengthening phase was lower compared to the DC casting alloy.