Abstract
In this paper, a comparative investigation was conducted on the tensile properties, microstructure evolution, and work hardening behavior of Fe18Mn0.6C and Fe18Mn1.0C TWIP steels at 298 K and 223 K by tensile tests and multi-scale microscopic characterization. With decreasing deformation temperature, two steels exhibit increased yield strength and ultimate tensile strength. However, the total elongation decreases for both, with Fe18Mn0.6C steel showing a more pronounced decrease. The work hardening behavior of two steels at 298 K and 223 K was analyzed. It is observed that the work hardening rate of both steels is higher at 223 K compared to 298 K, attributed to enhanced dislocation accumulation and the formation of deformation twins or martensite at lower temperatures. Particularly, Fe18Mn1.0C steel exhibits a continuous upward stage in work hardening at any temperature, driven by its higher dislocation density. On the other hand, Fe18Mn0.6C steel at 233 K shows a relatively stable trend in work hardening rate, attributed to the presence of martensite generated during deformation, which enhances its work hardening ability. Furthermore, the contribution of different strengthening mechanisms to the total flow stress was evaluated. The calculation results highlight dislocation strengthening as the primary source of flow stress in two steels at different temperatures. These findings provide theoretical support for understanding the mechanical properties of Fe–Mn–C TWIP steel at low temperature and optimizing the material design.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have