Microstructure Evolution and Performance of Laser-Remelted Ti-6Al-4V Alloy

Abstract

Herein, Ti-6Al-4V alloy was remelting by high-energy laser, the influence of laser energy density of mobile laser source on the evolution of solidification structure of Ti-6Al-4V alloy was studied, and the changes of relevant service performance of Ti-6Al-4V alloy after laser-remelting were explored. The results showed that there were four distinct regions: overheated zone, melting zone, heat-affected zone and substrate zone in Ti-6Al-4V alloy after laser remelting. The overheated zone and melting zone were dominated by primary α phase and secondary α phase, and a heat-affected zone was dominated by β phase. With the increase of laser energy density, the depth of molten pool and the range of melting zone in Ti-6Al-4V alloy increased, and the crystal phase distribution and grain size changed significantly. Laser-remelting Ti-6Al-4V alloy could still maintain a good passive state in the potentiodynamic polarization curve test, and the optimal laser power during remelting was 1200 W. This study proved that the crystal phase composition and grain size during the solidification process after laser-remelting were a key factor affecting the service performance of Ti-6Al-4V alloy.