Abstract
Wire-feed electron beam additive manufacturing (EBAM) is a promising manufacturing process for fabrication large-scale, fully dense and near net shape metallic components. However, limited knowledge is available on the wire-feed EBAM process of titanium alloys. In this work, the Ti-5Al-2Sn-2Zr-4Mo-4Cr near β titanium alloy sample was fabricated by the EBAM process and the effect of subtransus solution and aging treatment on the microstructure evolution and mechanical properties was investigated. The results reveal that the volume fraction of the primary α decrease dramatically from 48.6% to 8.9% with increasing the solution temperature from 750 °C to 850 °C. The ultimate tensile strength and yield strength increase monotonously with increasing of the solution temperature, while the elongation and reduction of area change conversely. The thickness of the secondary α (αS) increases significantly from 28.6 nm to 120.1 nm with the aging temperature increasing from 550 °C to 710 °C. The volume fraction and thickness of αS are sensitive to the aging temperature and strongly influence the mechanical properties. The quantitative relationship between the microstructure and mechanical properties was established. As a good result, the tensile properties of the post-deposition heat treated alloy at 400 °C can meet the standard requirements for wrought counterpart.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
