Microstructure evolution and grain refinement of ultrasonic-assisted soldering joint by using Ni foam reinforced Sn composite solder.

Abstract

In this investigation, ultrasonic-assisted soldering at 260°C in air produced high strength and high melting point Cu connections in 60s using Ni foam reinforced Sn composite solder. Systematically examined were the microstructure, grain morphology, and shear strength of connections made with various porosities of Ni foam composite solders. Results shown that Ni foams as strengthening phases could reinforce Sn solder effectively. The addition of Ni foam accelerated the metallurgical reaction due to great amount of liquid/solid interfaces, and refined the intermetallic compounds (IMCs) grains by ultrasonic cavitation. The joints had different IMCs by using Ni foam with different porosity. Layered (Cu,Ni)6Sn5 and (Ni,Cu)3Sn4 phases both existed in Cu/Ni60-Sn/Cu joint while only (Cu,Ni)6Sn5 IMCs grew in Cu/Ni98-Sn/Cu joint. As ultrasonic time increasing, Ni skeletons were dissolved and the IMCs were peeled off from substrates and broken into small particles. And then, the IMCs gradually dissociated into refined particles and distributed homogeneously in the whole soldering seam under cavitation effects. Herein, the Cu/Ni60-Sn/Cu joint ultrasonically soldered for 60s exhibited the highest shear strength of 86.9MPa, as well as a high melting point about 800℃ for the solder seam composed of Ni skeletons and Ni-Cu-Sn IMCs. The characterization indicated that the shearing failure mainly occurred in the interlayer of the soldering seam. The homogeneous distributed granular IMCs and Ni skeletons hindered the crack propagation and improved the strength of Cu alloy joints.