Abstract
Trabecular plates and rods determine apparent elastic modulus and yield strength of trabecular bone, serving as important indicators of bone's mechanical integrity in health and disease. Although trabecular bone's apparent-level mechanical properties have been widely reported, tissue mechanical properties of individual trabeculae have not been fully characterized. We systematically measured tissue mineral density (TMD)-dependent elastic modulus of individual trabeculae using microindentation and characterized its anisotropy as a function of trabecular type (plate or rod), trabecular orientation in the global coordinate (longitudinal, oblique, or transverse along the anatomic loading axis), and indentation direction along the local trabecular coordinate (axial or lateral). Human trabecular bone samples were scanned by micro-computed tomography for TMD and microstructural measurements. Individual trabecula segmentation was used to decompose trabecular network into individual trabeculae, where trabecular type and orientation were determined. We performed precise, selective indentation of trabeculae in each category using a custom-built, microscope-coupled microindentation device. Co-localization of TMD at each indentation site was performed to obtain TMD-to-modulus correlations. We found significantly higher TMD and tissue modulus in trabecular plates than rods. Regardless of trabecular type and orientation, axial tissue modulus was consistently higher than lateral tissue modulus, with ratios ranging from 1.13 to 1.41. Correlations between TMD and tissue modulus measured from axial and lateral indentations were strong but distinct: axial correlation predicted higher tissue modulus than lateral correlation at the same TMD level. To assess the contribution of experimentally measured anisotropic tissue properties of individual trabeculae to apparent-level mechanics, we constructed non-linear micro-finite element models using a new set of trabecular bone samples and compared model predictions to mechanical testing measurements. Heterogeneous anisotropic models accurately predicted apparent elastic modulus but were no better than a simple homogeneous isotropic model. Variances in tissue-level properties may therefore contribute nominally to apparent-level mechanics in normal human trabecular bone. © 2021 American Society for Bone and Mineral Research (ASBMR).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.